1、電子天平不能內校
(1)菜單中的校準功能設置在非校準的其他狀態如“LEST INT”“URRILAL”
改善菜單中的校準功能為“FACT"或“CAL INT”,正確退出菜單后,再執行內校。
2、電子天平在校準或檢測中斷出現“Abort"
(1)天平放置的環境太差
改善環境
(2)天平菜單中的參數設置不好
調入菜單后,用“RESET”功能,正確退出菜單,回到出廠設置
(3)稱重室內留有手的體溫
盡量減少這一人為因素
(4)被稱量物體的溫度未與天平達到等溫
將樣品放置在天平旁等溫。
(5)樣品存在吸水性、放水性、靜電、磁性……等特性。
3、電子天平的稱重結果明顯不準
(1)沒有去皮回零。
先去皮回零后,再稱量。
(2)天平?jīng)]有校準,或采用錯誤的外部砝碼校準
稱量前應先執行正確校準,再稱量。
(3)電源超出正確的工作電壓范圍電子分析天平
采取措施,穩定電源電壓。
4、電子天平的秤重結果不穩定,穩定提示燈不消失
(1)天平放置的環境太差
改善環境
(2)天平菜單中的參數設置不好
調入菜單后,用“RESET”功能,正確退出菜單,回到出廠設置
(3)稱重室內留有手的體溫
盡量減少這一人為因素
(4)被稱量物體的溫度未與天平達到等溫
將樣品放置在天平旁等溫。
(5)樣品存在吸水性、放水性、靜電、磁性……等特性。
5、電子天平在正常開機后顯示器上出現:000000閃動
(1)電子天平未裝稱盤
斷電后,先裝正確的稱盤,再開啟天平
(2)稱盤錯
用符合該天平的正確稱盤
(3)天平的稱盤與防風圈相碰
因安裝不當產生的原因,請找出相碰的原因重新正確安裝
(4)傳感器損壞
因電壓或電流過大,導致儀器集成電路損壞
稱重過載或者在放置搬運儀器時對天平發生過碰撞損